1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
|
# Import required modules
import RPi.GPIO as GPIO
import time
import math
# Constants: parameters that the caller cannot modify
# Delay: Minimum delay necessary after pull pin low to read input
delay = 0.0000005
# Encoder Class
# This controls the motor at the given IO
class Encoder:
def __init__(self, clk_pin, cs_pin, data_pin):
# Set the board IO (just in case it hasn't been done yet)
GPIO.setmode(GPIO.BCM)
# Setup class varaiable
self.offset=0
self.clk_pin = clk_pin
self.cs_pin = cs_pin
self.data_pin = data_pin
# Setup the IO
try:
GPIO.setup(self.clk_pin,GPIO.OUT)
GPIO.setup(self.cs_pin,GPIO.OUT)
GPIO.setup(self.data_pin,GPIO.IN)
# Setup the CS and CLK to be high
GPIO.output(PIN_CLK,1)
GPIO.output(PIN_CS,1)
except:
print("ERROR. Unable to setup the configuration required")
# Wait some time to before reading
time.sleep(0.5)
def set_zero(self):
# Take current position as zero
self.offset=self.read_position('Raw')
def clockup(self):
GPIO.output(self.clk_pin,1)
def clockdown(self):
GPIO.output(self.clk_pin,0)
def read_position(self, format):
# Most of this is based of timing diagram of encoder
# Pull CS low to start reading
GPIO.output(self.cs_pin,0)
# Delay necessary before reading is ready
time.sleep(delay*2)
data = 0
# Clockdown necessary before reading
self.clockdown()
# Go through 10 bits needed to read
for i in range(0,10):
# Clock up to start reading one bit
self.clockup()
# Shift data left and insert input
data<<=1
data|=GPIO.input(self.data_pin)
# Clock down after finish reading
self.clockdown()
# Pull CS high after finish reading
GPIO.output(self.cs_pin,1)
# Format with offset, Max is 1024
data=(data-self.offset)%1024
# Data is linearly mapped
if format=="Raw":
return data
elif format=="Degrees":
degrees=(data/1024.0)*360.0
return degrees
elif format=="Radian":
radians=(data/1024.0)*(2.0*math.pi)
return radians
else:
print("ERROR. Invalid format (Raw, Degrees, Radians)")
return None
|
